For a complete wiring diagram Refer to Section 8W.The controller is programmed during manufacturing with generic software to facilitate testing. This software does not have the proper calibrations to control a transmission in a vehicle. The check for generic software is made at power-up. If generic software is found, the MIL will light immediately and the MIL will stay on even if the fault is cleared, until the proper software is installed. Note: Transmission will be placed in limp-in mode.When Monitored:Check for generic software is made at power-up.Set Condition:If generic software is found, the MIL will light immediately. This DTC is designed to signal the technician that the controller still has generic software installed.Possible CausesPCM - PROGRAMMING ERRORAlways perform the Pre-Diagnostic Troubleshooting procedure before proceeding. (Refer to 21 - TRANSMISSION/TRANSAXLE/AUTOMATIC - 42RLE - STANDARD PROCEDURE) 1. CONTROL MODULE PROGRAMMING ERRORController is programmed with generic software and will not allow the correct vehicle Powertrain management.Record the controller part number.Update the controller with the correct software in accordance with the Service Information.Verify that the controller updated successfully.Test CompletePerform 42RLE TRANSMISSION VERIFICATION TEST. (Refer to 21 - TRANSMISSION/TRANSAXLE/AUTOMATIC - 42RLE - STANDARD PROCEDURE)