For a complete wiring diagram Refer to Section 8WThe controller is programmed during manufacturing with generic software to facilitate testing. However, generic software does not have the proper calibrations to control a transmission in a vehicle. The check for generic software is made at power-up. If generic software is found , the MIL will light immediately and the MIL will stay on even if the fault is cleared, until the proper software is installed. Note: Transmission will be placed in limp-in mode.When Monitored:Check for generic software is made at power-upSet Condition:If generic software is found, the MIL will light immediately. This DTC is designed to inform the technician that the controller still has generic software installed.Possible CausesPCM - PROGRAMMING ERRORAlways perform the Pre-Diagnostic Troubleshooting procedure before proceeding. (Refer to 21 - TRANSMISSION/TRANSAXLE/AUTOMATIC - 45RFE/545RFE - STANDARD PROCEDURE) 1. CONTROL MODULE PROGRAMMING ERRORController is programmed with generic software and will not allow the correct vehicle Powertrain management.With the scan tool. Record the vehicles controller part number.Select Use Controller Part Number under the Flash Tab.Flash the controller with the correct software.Verify the controller flashed successfully.Test CompletePerform 45RFE/545RFE TRANSMISSION VERIFICATION TEST. (Refer to 21 - TRANSMISSION/TRANSAXLE/AUTOMATIC - 45RFE/545RFE - STANDARD PROCEDURE)