ASBS VERIFICATION TESTDiagnostic Test1. PERFORM ASBS VERIFICATION TESTBefore removing the ASBS harness connector, clean the connector and locking cam area of dirt and debris. Failure to do so can result in the connector being jammed or damage
to the locking cams on the harness connector or module. Do not force the assist arm when releasing or installing the harness connector.If the SKIM, PCM or FCM was replaced, refer to the service information for proper programming procedures.- Disconnect all jumper wires and reconnect all previously disconnected components and connectors.
- Ensure that all accessories are turned off.
- Ensure that the battery is fully charged.
- With the scan tool, record and erase all DTC(s) from the ASBS
- Start and run the engine for 2 minutes while operating all functions of the system that caused the original concern.
- When a Stabilizer System DTC diagnostic is complete and all repairs have been made, running the Stabilizer Motor System Test and/or LED System Test can also provide verification
that the DTC has been repaired and the system is operating normally.
- Turn the ignition off, wait 5 seconds, then turn the ignition on. Using the scan tool, read DTC(s) from the ASBS.
Are any ASBS DTC(s) present or is the original condition still present?Yes- The repair is not complete. Refer to the related category for the DTC or symptom that is still present.
No- The repair is complete.