Stabilizer bar will ENGAGE with the loss of ignition switch, vehicle speed, or stabilizer bar switch signalsThe bar will DISENGAGE when ALL the following conditions are met:vehicle speed under 18 MPHautomatically at speeds over 14 MPH if the switch is in the ON positiontransfer case in 4 HI or 4 LOstabilizer bar switch message received for DISENGAGEignition switch in the RUN or START positionno stabilizer bar faults detectedThe bar will ENGAGE when ANY of the following conditions are met:vehicle speed is greater or equal to 18 MPHstabilizer bar switch message received for ENGAGEtransfer case in 2WD or neutralThe disconnecting stabilizer bar system will latch the momentary switch (2) through software for an ignition switch OFF condition if the stabilizer bar was DISENGAGED and the transfer case was in 4LO at ignition switch OFF. Upon ignition switch RUN/START and the transfer case in 4LO, the system checks to verify all conditions to DISENGAGE the stabilizer bar are correct and then DISENGAGE the stabilizer bar without switch input.The stabilizer switch LED will:Be ON SOLID when the stabilizer bar is DISENGAGEDturn ON BLINKING when the stabilizer bar is transitioning from one state to anotherturn ON BLINKING when a request is received but conditions to DISENGAGE are not correctbe turned OFF when the stabilizer bar is ENGAGEDturn ON FAST BLINKING when there is a fault detected for the stabilizer barturn OFF when the system is in diagnostic mode