For a complete wiring diagram Refer to Section 8W.When Monitored:Throttle motor is powered and no matured faults related to TP Sensors.Set Condition:When secondary software determines that TPS 1 and TPS 2 signals do not match for a period of time. One trip fault. ETC lamp will flash.Possible CausesPCM NEEDS TO BE PROGRAMMEDPCMAlways perform the Pre-Diagnostic Troubleshooting procedure before proceeding. (Refer to 9 - ENGINE - DIAGNOSIS AND TESTING).1. PROGRAM THE POWERTRAIN CONTROL MODULEVerify the PCM is at the latest calibration (flash level).An intermittent loss of power to the PCM without performing an ETC Relearn procedure may cause this DTC to set.Flash the Powertrain Control Module per Service Information if any updates are available.Start the engine.Allow the engine to reach normal operating temperature.Operate the accelerator pedal. (do not exceed 3500 rpm)With a scan tool, select View DTCs.Diagnose any other DTCs that may have set with the P060E.Does this DTC reset by itself?YesReplace and reprogram the Powertrain Control Module per Service Information.Perform the POWERTRAIN VERIFICATION TEST. (Refer to 9 - ENGINE - STANDARD PROCEDURE) NoTest Complete.