For a complete wiring diagram Refer to Section 8W.When Monitored:With the vehicle running, ETC Motor not in Limp Home mode, and the TPS adaptation is complete.Set Condition:The PCM recognizes too large of an error between the actual position of the Throttle Plate and the Set Point position. One trip fault and the code will set within 5 seconds. Three good trips to turn off the MIL ETC light is flashing.Possible CausesTHROTTLE BODY ASSEMBLYLOW BATTERY VOLTAGEPCMAlways perform the Pre-Diagnostic Troubleshooting procedure before proceeding. (Refer to 9 - ENGINE - DIAGNOSIS AND TESTING).1. ACTIVE DTCWhen this DTC is Active the engine speed, torque, and vehicle speed are limited to a Limp in mode.Before continuing visually inspect the throttle blade and bore for any obstructions. Icing of the throttle body may have caused this code to set.Low battery voltage can also cause excessive current draw, in very hot and very cold ambient temperature. Make sure the battery can pass a load test before continuing.Diagnose any 5-Volt Supply, Battery, and TP Sensor DTCs before continuing.Ignition on, engine not running.With a scan tool, select View DTCs.Is the DTC Active at this time?YesGo To 2NoRefer to the INTERMITTENT CONDITION Diagnostic Procedure.Perform the POWERTRAIN VERIFICATION TEST. (Refer to 9 - ENGINE - STANDARD PROCEDURE) 2. THROTTLE PLATE INSPECTION Turn the ignition off.Remove the Air Cleaner Assembly from the Throttle Body.Check for any signs of a foreign material (ice or dirt) on the Throttle Plate or in the bore causing the Throttle Plate to stick.Manually open and close the throttle plate using your hands.Does the Throttle Plate move?YesGo To 3NoRemove the debris if possible or replace the Throttle Body Assembly. Disconnect the Battery when replacing the Throttle Body Assembly. After installation is complete, use a scan tool and select the ETC RELEARN function.Perform the POWERTRAIN VERIFICATION TEST. (Refer to 9 - ENGINE - STANDARD PROCEDURE) 3. THROTTLE POSITION WITHIN 2° DEGREES OF DESIRED THROTTLE POSITIONStart the engine.Allow the engine to reach normal operating temperature.With a scan tool, monitor the Actual Throttle Position and Desired Throttle Position.Compare the Actual Throttle Position and the Set Point Throttle Position.Is the Actual Throttle Position within 2° degrees of the Desired Throttle Position?YesGo To 4NoReplace the Throttle Body Assembly. Disconnect the Battery when replacing the Throttle Body Assembly. After installation is complete, use a scan tool and select the ETC RELEARN function.Perform the POWERTRAIN VERIFICATION TEST. (Refer to 9 - ENGINE - STANDARD PROCEDURE) 4. ETC OPERATIONIgnition on, engine not running.With a scan tool, actuate the Electronic Throttle Control Motor.It may be necessary to use a mirror to see the throttle blade.Observe the throttle blade.Make sure the motion of the throttle blade is smooth and that it opens and closes.Did the ETC motor operate properly?YesRefer to the INTERMITTENT CONDITION Diagnostic Procedure.Perform the POWERTRAIN VERIFICATION TEST. (Refer to 9 - ENGINE - STANDARD PROCEDURE) NoReplace the Throttle Body Assembly. Disconnect the Battery when replacing the Throttle Body Assembly. After installation is complete, use a scan tool and select the ETC RELEARN function.Perform the POWERTRAIN VERIFICATION TEST. (Refer to 9 - ENGINE - STANDARD PROCEDURE)