1. CHECKING THE EXHAUST SYSTEM FOR LEAKSTurn the ignition off.Raise the vehicle in accordance with the Service Information.The normal operating temperature of the exhaust system is very high. Never work around or attempt to service any part of the exhaust system until it has cooled. Special care should be taken when working near the catalytic converter. The temperature of the converter rises to a high level after a short period of engine operating timeConnect Exhaust Cone #8404-EC or #8404–EC to Air Pressure Regulator (with hose) #W-18-MIL-1146AS.The air pressure must not exceed 27.6 kPa (4 psi), otherwise engine damage can occur.Attach shop air to the air pressure regulator.Adjust the Air Pressure Regulator to 27.6 kPa (4 psi)Insert the exhaust cone into the vehicle tail pipe.If the vehicle is equipped with dual exhaust. Use the #8404-ECT with equipped attached plug, plug one side of the dual exhaust pipe. Pressurize the other as described above.Apply SNOOP leak finder liquid or a mixture of liquid dish soap and water to the following areas: - All welded joints from the exhaust manifold to 152.4 mm (6 inches) behind the downstream O2 sensor - O2 sensor seal points - O2 sensor boss welds - Flange/joint connection(s) - Exhaust manifold to cylinder head connection(s) - EGR solenoid gasket base and tube seal points (if equipped)Watch for the liquid/soapy water to bubble.Use the following definitions to help determine if system or component repair/replacement is necessary:Type 1 Leak is defined as a leak where very small foam like bubbles 1 mm (0.04 of an inch) or less appear.Any Type 1 or greater leaks found in welded joints, O2 sensor seal points or O2 sensor boss welds must be repaired or the component must be replaced.Type 2 Leak is defined as a leak where larger bubbles pea size, 8 mm (0.3 of an inch) or greater appear.Any Type 2 or greater leaks found in flange or joint connections, exhaust manifold to cylinder head connections, or EGR gasket and tube seal points must be repaired or the components must be replacedLeak LocationRepair required if results at 27.6 kPa (4 psi) reveal bubble size:Welded jointsType 1, 1 mm (0.04 of an inch) or greaterO2 Sensor seal pointsType 1, 1 mm (0.04 of an inch) or greaterO2 Sensor boss weldsType 1, 1 mm (0.04 of an inch) or greaterFlange / joint connectionsType 2, 8 mm (0.3 of an inch) or greaterExhaust Manifold to cylinder head connectionsType 2, 8 mm (0.3 of an inch) or greaterEGR gasket and tube seal pointsType 2, 8 mm (0.3 of an inch) or greaterIf a leak is found that matches the above definition, repair or replace the component as necessary.Once the repair is complete, repeat the procedure to verify that all leaks have been repaired.Were any exhaust leaks found?YesRepair or replace the leaking exhaust parts as necessary.Perform the PCM Verification Test.(Refer to 9 - ENGINE - STANDARD PROCEDURE)NoTest complete.