For a complete wiring diagram Refer to Section 8WThe tire pressure sensor actively monitors the air pressure and air temperature inside the tire, the sensor internal battery status, and the radial acceleration of the wheel. Each sensor has a unique ID code. The sensor transmits the data at regular intervals via an encoded signal to a receiver circuit located in the Wireless Control Module (SKREEM).When Monitored:With vehicle speed greater than 15 m.p.h. (24 km/h).Set Condition:The WCM (SKREEM) will monitor the signals from the four active road tire sensors. A loss of signal error is detected when eight consecutive blocks of data are not received or cannot be accurately decoded within a maximum period of 10 minutes. An internal sensor hardware error condition will be set when an error in the accelerometer, pressure sensor, or temperature sensor is detected.Possible CausesINTERMITTENT TIRE PRESSURE SENSOR INTERNAL DTCSPARE TIRE IN USETIRE PRESSURE SENSORWIRELESS CONTROL MODULE (SKREEM)1. DTC STATUS IS ACTIVEIf the following conditions are present:– Tire Pressure Sensor Internal DTC (Active) – Spare Tire is not equipped with a Tire Pressure Sensor– Spare Tire is currently on the vehicle Repair the tire and place it back on the vehicle. Test drive the vehicle. If the DTC(s) reset continue with the diagnostic procedure. Turn the ignition on.With the scan tool, select View DTCs in the Wireless Control Module (SKREEM).Is the DTC status Active at this time?YesGo to 2 NoGo to 42. TIRE PRESSURE SENSORWhen working with vehicles equipped with the base tire pressure monitoring system the correct tire that set the fault must be identified. Following the below procedure will help in identifying the correct tire. 1. Set all tire pressures to the recommended specifications and recheck for fault/alert. 2. Turn the ignition on. 3. Starting with the left front wheel, deflate the tire to 20 PSI and wait 2 minutes. The fault will set once the pressure has reached 20 PSI within the 2 minute time frame. 4. If the TPM fault was detected and not associated to this Sensor/Transmitter, repeat the process until the faulty Sensor/Transmitter has been identified. Once a fault/alert has set, it will establish the location of the tire pressure sensor/transmitter. Repeat steps until the applicable Tire Pressure Sensor/Transmitter has been located. Turn the ignition off.Replace the Tire Pressure Sensor in accordance with the Service Information.With the scan tool, clear DTCs in the Wireless Control Module (SKREEM).Test Drive the vehicle for a minimum of 10 minutes with vehicle speed greater than 15 m.p.h.With the scan tool, select View DTCs in the Wireless Control Module (SKREEM).Does the DTC reset or is the status Active for this DTC?YesGo to 3NoTest Complete.Perform TPM VERIFICATION TEST. (Refer to 22 - TIRES/WHEELS/TIRE PRESSURE MONITORING - STANDARD PROCEDURE)3. WIRELESS CONTROL MODULE (SKREEM)View repair.RepairReplace the Wireless Control Module (SKREEM) in accordance with the Service Information. Perform TPM VERIFICATION TEST. (Refer to 22 - TIRES/WHEELS/TIRE PRESSURE MONITORING - STANDARD PROCEDURE)4. INTERMITTENT TIRE PRESSURE SENSOR DTCThe conditions necessary to set this DTC are not present at this time.Refer to any Technical Service Bulletins that may apply to this condition.With the scan tool, clear DTCs in the Wireless Control Module (SKREEM).Test Drive the vehicle for a minimum of 10 minutes with vehicle speed greater than 15 MPH (24 km/h).With the scan tool, select View DTCs in the Wireless Control Module (SKREEM).Does the DTC reset or is the status Active for this DTC?YesReturn to the beginning of this test and perform the diagnostic procedure as necessary.NoTest complete.Perform TPM VERIFICATION TEST. (Refer to 22 - TIRES/WHEELS/TIRE PRESSURE MONITORING - STANDARD PROCEDURE)