For a complete wiring diagram Refer to Section 8W.When Monitored:With the ignition on.Set Condition:The amplifier detects a short to battery condition on the output circuit.Possible Causes(X208) AMPLIFIED RIGHT FRONT SPEAKER (+) CIRCUIT SHORT TO VOLTAGE(X298) AMPLIFIED RIGHT FRONT SPEAKER (-) CIRCUIT SHORT TO VOLTAGEAMPLIFIER1. CHECK FOR AN INTERMITTENT CONDITIONTurn the ignition on, then off, and then on again.With the scan tool, read Amplifier DTCs.Does the scan tool display active: B1471-CHANNEL 4 AUDIO SPEAKER OUTPUT CIRCUIT HIGH?YesGo To 2NoThe condition that caused this symptom is currently not present. Check for an intermittent condition by inspecting the related wiring harness for chafed, pierced, pinched, and partially broken wires. Also, inspect the related connectors for broken, bent, pushed out, spread, corroded, or contaminated terminals. Repair as necessary.Perform the BODY VERIFICATION TEST - VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)2. CHECK FOR VOLTAGE ON THE (X208) AMPLIFIED RIGHT FRONT SPEAKER (+) CIRCUIT

Turn the ignition off.Disconnect the Amplifier C1 harness connector.Disconnect the Amplified Right Front Speaker harness connector.Turn the ignition on.Measure for voltage on the (X208) Amplified Right Front Speaker (+) circuit.Is the voltage above 10.0 volts?YesRepair the (X208) Amplified Right Front Speaker (+) circuit for a short to voltage.Perform the BODY VERIFICATION TEST - VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)NoGo To 33. CHECK FOR VOLTAGE ON THE (X298) AMPLIFIED RIGHT FRONT SPEAKER (-) CIRCUIT

Measure for voltage on the (X298) Amplified Right Front Speaker (-) circuit.Is the voltage above 10.0 volts?YesRepair the (X298) Amplified Right Front Speaker (-) circuit for a short to voltage.Perform the BODY VERIFICATION TEST - VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)NoReplace the amplifier in accordance with the service information.Perform the BODY VERIFICATION TEST - VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)