Place the latch assembly into the door opening and install the carrier plate (7) onto the door.Install the latch screws (4) and tighten to 8 N·m (71 in. lbs.) top screws first.Install the latch bracket screw (3).Install the 10 carrier plate screws (5) and tighten to 10 N·m (90 in. lbs.).Install the outside door handle nut (2) through the hole in the inner door and tighten to 4.5 N·m (40 in. lbs.).Install the inside door handle screw (1) and tighten to 8.5 N·m (75 in. lbs.).

Slowly lower the glass (1) all the way down into the regulator lift plate (3) and seat the glass clip (4) fully until a snap sound is heard.Seal the glass disconnect holes with a suitable foam tape or equivalent.

Install the trim panel (1), (Refer to 23 - BODY/DOOR - FULL FRONT/TRIM PANEL - INSTALLATION).