P1715-RESTRICTED MANUAL VALVE IN T3 RANGEFor a complete wiring diagram Refer to Section 8W- When Monitored:Whenever the PRNDL code indicates Temp 3.
- Set Condition:This DTC sets when conditions for the DTC P1776 are satisfied or 3 unsuccessful attempts to engage 1st gear while the shifter is in the temp 3 zone. This indicates a restricted port at the manual
valve because the shifter is not fully engaged in the drive position.
Possible Causes
RELATED TRANSMISSION DTC'S PRESENT
CUSTOMER DRIVING HABITS
MISADJUSTED SHIFTER
Always perform the 45RFE/545RFE Pre-Diagnostic Troubleshooting Procedure before proceeding. (Refer to 21 - TRANSMISSION/TRANSAXLE/AUTOMATIC
- 45RFE/545RFE - STANDARD PROCEDURE) Diagnostic Test1. DETERMINING IF RELATED DTC'S ARE PRESENTWith the scan tool, check DTCs.Are any of the following DTCs P0731, P0732, P0733, P0734, P0736, or P0716 present?Yes- Refer to the Transmission category and perform the appropriate symptom.
No- Go To 2
2. CHECK SHIFTER ADJUSTMENTCheck Shifter adjustment per the Service Information.Is the shifter properly adjusted?Yes- Go To 3
No- Adjust the Shifter Assembly per the Service Information.
- Perform 45RFE/545RFE TRANSMISSION VERIFICATION TEST. (Refer to 21 - TRANSMISSION/TRANSAXLE/AUTOMATIC - 45RFE/545RFE - STANDARD PROCEDURE)
3. CHECK CUSTOMER DRIVING HABITThis DTC can be set if the customer rests their hand on the shift lever while they are driving. The transmission can be put in the T3 position if just enough forward pressure is exerted on
the shift lever.When this occurs, the feed port to the clutch is restricted, the transmission will declare neutral, and this DTC will be set. The customer should be informed not to rest their hand on the shifter
while driving.This DTC can also be set by simply bumping the shift lever toward neutral while accelerating.With the scan tool, check the DTC EVENT DATA to help identify the conditions in which the DTC was set.If there are no possible causes remaining, view repair.Repair- This DTC can be set by putting too much forward pressure on the shift lever while it is in the OD position. Make sure the customer is informed.
- Perform 45RFE/545RFE TRANSMISSION VERIFICATION TEST. (Refer to 21 - TRANSMISSION/TRANSAXLE/AUTOMATIC - 45RFE/545RFE - STANDARD PROCEDURE)