For a complete wiring diagram Refer to Section 8W.When Monitored:With the ignition on.Set Condition:When the Left Front Wheel Speed Sensor (WSS) Signal reading is different from the readings received from the other WSS's at a vehicle speed above 40 km/h (25 mph). The Anti-Lock Brake Module compares WSS readings from side-to-side on an axle and front-to-rear.Possible CausesLEFT FRONT WSS LOOSE — B8, B9 CIRCUITS/CONNECTOR/TERMINAL DAMAGEIMPROPER LEFT FRONT TIRE PRESSURE/MISMATCHED TIRESLEFT FRONT TONE WHEEL/BEARING DAMAGELEFT FRONT WSSANTI-LOCK BRAKE MODULE1. CHECK FOR DTC C1014-LEFT FRONT WHEEL SPEED COMPARATIVE PERFORMANCEThis DTC must be active for the results of this test to be valid.Turn the ignition on.With the scan tool, record and erase DTCs.Road test the vehicle over 40 km/h (25 mph).Vehicle must be driven above 40 km/h (25 mph) for set conditions to be met.With the scan tool, read DTCs.Does the scan tool display: C1014-LEFT FRONT WHEEL SPEED COMPARATIVE PERFORMANCE active?YesGo To 3NoGo To 2 2. CHECK WHEEL SPEED SENSOR SIGNALSTurn the ignition on.With the scan tool, monitor and graph ALL the WSS speeds and compare graph while an assistant drives the vehicle.If graph shows periodic dropouts pay close attention to the tone wheel.Slowly accelerate as straight as possible from a stop to 40 km/h (25 mph).Is the Left Front WSS speed showing 0 km/h (0 mph) or not matching other wheels or showing erratic behavior?YesGo To 3 NoThe condition that caused the symptom is currently not present. Inspect the related wiring for a possible intermittent condition. Look for any chafed, pierced, pinched, or partially broken wires.Refer to the ABS-INTERMITTENT CONDITION TEST. (Refer to 5 - BRAKES - DIAGNOSIS AND TESTING)3. CHECK FOR IMPROPER LEFT FRONT TIRE PRESSURE/MISMATCHED TIRESTurn the ignition off.Check and adjust the Left Front Tire pressure.Check and adjust all other tire pressures.Inspect for mismatched tires on vehicle.Is the Left Front Tire improperly inflated or mismatched tires on vehicle?YesRepair as necessaryPerform ABS VERIFICATION TEST. (Refer to 5 - BRAKES - STANDARD PROCEDURE)NoGo To 44. CHECK LEFT FRONT WSS LOOSENESS, INSPECT B8, B9 CIRCUITS/TERMINALS FOR DAMAGECheck all terminals for broken, bent, pushed out, or corroded terminalsInspect the Anti-Lock Brake Module harness connector, Left Front WSS, and Left Front WSS harness connector.Inspect the Left Front WSS for looseness, excessive corrosion and not properly fastened.Inspect the (B8) Left Front WSS Signal and (B9) Left Front WSS Supply circuits between the Left Front WSS and Anti-Lock Brake Module for damage.Is the Left Front WSS loose or any of the wiring/connectors/terminals damaged?YesRepair as necessary.Perform ABS VERIFICATION TEST. (Refer to 5 - BRAKES - STANDARD PROCEDURE)NoGo To 55. CHECK LEFT FRONT WHEEL SPEED SENSOR FOR DAMAGERemove the Left Front Wheel Speed SensorInspect the Left Front Wheel Speed Sensor face for damage. Is the Left Front Wheel Speed Sensor damaged?YesReplace sensor and hub assembly.Perform ABS VERIFICATION TEST. (Refer to 5 - BRAKES - STANDARD PROCEDURE)NoGo To 66. CHECK LEFT FRONT TONE WHEEL/BEARING FOR DAMAGEInspect the Left Front Tone Wheel/Bearing for damage, missing teeth, cracks, corrosion or looseness.The Tone Wheel teeth should be perfectly square, not bent, or nicked.Is the Left Front Tone Wheel/Bearing damaged?YesRepair as necessary.Perform ABS VERIFICATION TEST. (Refer to 5 - BRAKES - STANDARD PROCEDURE)NoGo To 77. LEFT FRONT WHEEL SPEED SENSORReplace the Left Front Wheel Speed Sensor in accordance with the Service Information.Perform ABS VERIFICATION TEST. (Refer to 5 - BRAKES - STANDARD PROCEDURE)Road test the vehicle over 40 km/h (25 mph).Vehicle must be driven above 40 km/h (25 mph) for set conditions to be met.With the scan tool, read ABS DTCs.Did DTC C1014-LEFT FRONT WHEEL SPEED COMPARATIVE PERFORMANCE reset?YesReplace the Anti-Lock Brakes Module in accordance with the Service Information.Perform ABS VERIFICATION TEST. (Refer to 5 - BRAKES - STANDARD PROCEDURE)NoTest Complete.