Install the intake camshaft oil seal (2).

Make sure that the camshaft locking tool is correctly installed.Install the front camshaft cap.Install the cylinder head cover.(Refer to 9 - ENGINE/CYLINDER HEAD/CYLINDER HEAD COVER(S) - INSTALLATION)

Install the camshaft sprocket (2). Torque the bolt to 64 N·m (47 ft.lbs.).Remove the camshaft locking tool.Install the exhaust camshaft seal (1).

DO NOT remove the timing belt from the package until it's ready to be installed. DO NOT expose timing belt to oil, grease or water contamination. DO NOT crimp belt at a sharp angle. DO NOT clean belt, pulleys or tensioner with solvent. Check that pulleys and bearings are not seized or damage before installing belt.Install timing belt. Adjust the timing belt tensioner (turn it clockwise) by lining up the center notch with the aluminum cover dowel pin. Tighten the retaining bolt to 45 N·m. (33 (lbs. ft.)(Refer to 9 - ENGINE/VALVE TIMING/TMNG BELT/CHAIN TENSIONER&PULLEY - DJUSTMENTS).

Install the lower front cover. Torque the bolts to 11 N·m (97 lbs. in.)Install the vibration damper (1). Torque the bolt to N·m (80 lbs. ft.)

Install the upper front cover (2). Torque the bolts to 11 N·m (97 lbs in.)

Install the idler pulley bracket (1).

Install the front engine lifting bracket. Torque the bolts to 45 N·m (33 ft.lbs.)

Remove crankshaft locking tool.Install accessory drive belt (Refer to 7 - COOLING/ACCESSORY DRIVE/DRIVE BELTS - INSTALLATION) .Install cooling fan and fan drive viscous clutch assembly (Refer to 7 - COOLING/ENGINE/FAN DRIVE VISCOUS CLUTCH - INSTALLATION) .Connect negative battery cable.