For a complete wiring diagram Refer to Section 8W.When Monitored:With the Front Fog Lamps activated.Set Condition:When the Totally Integrated Power Module (TIPM) detects a LOW condition.Possible Causes(L89) FRONT LEFT FOG LAMP CONTROL CIRCUIT SHORT TO GROUNDFRONT LEFT FOG LAMP BULBTOTALLY INTEGRATED POWER MODULE1. INTERMITTENT CONDITIONTurn the ignition on.With the scan tool, clear all DTC's.Turn the Front Fog Lamps on.With the scan tool, read DTC's.Does the scan tool display active: B16F8–FRONT LEFT FOG LAMP CONTROL CIRCUIT LOW?YesGo To 2 NoThe condition that caused this symptom is currently not present. Check for an intermittent condition by inspecting the related wiring harness for chafed, pierced, pinched, and partially broken wires. Also, inspect the related connectors for broken, bent, pushed out, spread, corroded, or contaminated terminals. Repair as necessary.Perform the BODY VERIFICATION TEST - VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE) 2. FRONT LEFT FOG LAMP BULBTurn the ignition off.Disconnect the Front Left Fog Lamp Bulb.Turn the ignition on.With the scan tool, read DTC's.Does the DTC reset?YesGo To 3NoReplace the Front Left Fog Lamp Bulb in accordance with the Service Information.Perform the BODY VERIFICATION TEST - VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)3. (L89) FRONT LEFT FOG LAMP CONTROL CIRCUIT SHORT TO GROUNDTurn the ignition off.Disconnect the TIPM C4 harness connector.Measure the resistance between ground and the (L89) Front Left Fog Lamp Control circuit.Is the resistance above 10k ohms?YesReplace the Totally Integrated Power Module (TIPM) in accordance with the Service Information.NoRepair the (L89) Front Left Fog Lamp Control circuit for a short to ground.Perform the BODY VERIFICATION TEST - VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)