For a complete wiring diagram Refer to Section 8W.When Monitored:With the ignition on.Set Condition:If an Occupant Restraint Controller (ORC) configured for vehicles without side airbags is installed in a vehicle with side airbags.Possible CausesTOTALLY INTEGRATED POWER MODULE (TIPM)OCCUPANT RESTRAINT CONTROLLER (ORC)1. VERIFY THAT DTC B1BA5-AIRBAG SQUIB CONFIGURATION MISMATCH IS ACTIVEEnsure the battery is fully charged.Turn the ignition on.With the scan tool, read ORC DTC.Does the scan tool display active: B1BA5-AIRBAG SQUIB CONFIGURATION MISMATCH?YesGo To 2NoGo To 52. CHECK FOR ACTIVE TIPM DTCVerify that the vehicle is equipped with a Occupant Classification System (OCS).With the scan tool, read the active TIPM DTC.Is active TIPM DTC present?YesDiagnose and repair the active TIPM DTC.Refer to the Table of Contents in this Section for a complete list of symptoms.NoGo To 3Perform *AIRBAG SYSTEM VERIFICATION TEST - VER 1.3. CHECK ORC PART NUMBER WITH SCAN TOOLWith the scan tool, select ECU View, select ORC, select ECU Details, and read the ORC part number.Is the part number correct for the vehicle?YesGo To4NoReplace the ORC in accordance with Service Information.Perform *AIRBAG SYSTEM VERIFICATION TEST - VER 1.4. CHECK VIN WITH SCAN TOOLWith the scan tool, read the VIN.Is the correct VIN displayed?YesReplace the ORC in accordance with Service Information.Perform *AIRBAG SYSTEM VERIFICATION TEST - VER 1.NoReplace or reprogram the Totally Integrated Power Module (TIPM) in accordance with Service Information.Perform *AIRBAG SYSTEM VERIFICATION TEST - VER 1.5. TEST FOR INTERMITTENT CONDITIONWith the scan tool, record and erase all DTC from all Airbag modules.If any ACTIVE codes are present they must be resolved before diagnosing any stored codes.To avoid serious or fatal injury, turn the ignition off, disconnect the battery and wait two minutes before proceeding.Using the wiring diagram/schematic as a guide, inspect the wiring and connectors.Look for chafed, pierced, pinched, or partially broken wires and broken, bent, pushed out, spread, corroded, or contaminated terminals.The following additional checks may assist you in identifying a possible intermittent problem.Reconnect any disconnected components and harness connector.To avoid serious or fatal injury, turn the ignition on, then reconnect the battery.With the scan tool, monitor active codes as you work through the following steps.To avoid serious or fatal injury, maintain a safe distance from all airbags while performing the following steps.Wiggle the wiring harness and connectors of the related airbag circuit or component.If only stored codes return, continue the test until the problem area has been isolated.In the previous steps you have attempted to recreate the conditions responsible for setting the active DTC in question.Does the scan tool display any ACTIVE DTC?YesSelect appropriate symptom from Symptom List.No No problem found at this time. Erase all codes before returning vehicle to customer.