When Monitored:With the Ignition on.Set Condition:This DTC will be set when the VIN stored in the PCM does not match the VIN stored in the Occupant Restraint Controller (ORC). The ORC does not support a stored B2201 DTC.Possible CausesINCORRECT PCMOCCUPANT RESTRAINT CONTROLLER (ORC)1. VERIFY THAT DTC B2201-CALIBRATION MISMATCH IS ACTIVETurn the ignition on.With the scan tool, read ORC DTC. Ensure the battery is fully charged.Does the scan tool display active: B2201-CALIBRATION MISMATCH?YesGo To 2NoTest Complete.2. CHECK VIN IN PCMWith the scan tool compare the VIN that is programmed into the PCM to the VIN stored in the ORC.Does the VIN programmed into the PCM match the VIN stored in the ORC?YesGo To 3NoReplace and program the Powertrain Control Module in accordance with the service information. Ensure the PCM is replaced with the correct vehicle line PCM.3. REPLACE THE OCCUPANT RESTRAINT CONTROLLERTo avoid serious or fatal injury, turn the ignition off, disconnect the battery and wait two minutes before proceeding.If the airbag control module is dropped at any time, it must be replaced. Failure to take the proper precautions can result in accidental airbag deployment and serious or fatal injury.View repair.Repair Replace the ORC in accordance with the service information.Perform the *AIRBAG SYSTEM VERIFICATION TEST - VER 1